Step 1:
Place
Place and center base frame in the truck bed. Place front pins touching the
front wall of the pickup bed.
Step 2:
Measure
Center the front by measuring the distance between the front pins and the
side of the pickup bed.
Step 3:
Marking the pins
Using a felt pen, mark the top of the front pins where they hit the front
wall of the bed.
Step 4:
Drilling the holes
First, drill pilot holes using a smaller bit. Follow by drilling 9/16\x94
holes where the pins will go through the bed. NOTE: Using a hacksaw, it may
be necessary to shorten/cut the front pins so they do not hit the cab.
Step 5:
Mark rear pin With the front pins through the front holes, center,
measure, and mark the rear pin. NOTE: Before drilling, make sure not to
drill through the gas tank, wiring, spare tire, ...etc!
Step 6:
Drill near pin
First, drill pilot hole. Follow by drilling a 1/2” hole through the floor of
the pickup bed. LOOK BEFORE DRILLING!
Step 7:
Place the base
Slide front pins into place and drop rear pin into rear hole. OPTIONAL: Rear
pin is threaded if you choose to secure the BedSlide with a bolt. The top is
now ready to install.
Step 8:
Install the platform
Place the top deck by aligning the bearings into the base track bearing
notches. Turn the T-handle allowing the deck to fall into the track. Holding
the T-handle in the open position, slide the deck forward until it stops,
lift the rear over the stops and lower the deck into position. Your BedSlide
is now installed!
Our online ordering system will
keep all information provided completely secure using SSL encryption
technology. Your credit card number will not be retained on our server.
It is securely passed to our bank for processing and deleted immediately
thereafter. Additionally, All information provided by you will be
completely confidential. Truck Specialties Inc. does not provide
customer information, mailing list or other data to any outside firms or
individuals.
